BLASER SCOPE MOUNT WITH RINGS

 

Every Blaser rifle or combination gun can be matched with an original Blaser Saddle Mount.

After being zeroed in once, the rifle scope can be removed and replaced as often as you choose, without tools, with 100% return to zero - guaranteed.

This provides adaptability to employ different scopes on the same barrel. This allows you to adapt your rifle to any situation by switching the optic as well as your cartridge load. Many Blaser owners have different scope for different scenarios e.g.-a low power scope / red dot sight ready for bush stalking/driven hunts and also a high power scope for longer range shots.

Four discreet indentations on the chamber end of the barrel take the all-in-one mount without tension.

The barrel is totally free to oscillate.

No further work is required on the firearm, and there is no need for any other bases or mounts that can interfere with your sight picture or the aesthetic of your rifle.

This product includes 1x new style scope mount fitted with 1x set (pair) of matching rings.

• Scope mount bases are not available on their own, they are matched and sold with a set of rings

Ring sizes:

• 1" (25.4mm)
• 1" High
• 30mm
• 34mm
• 34mm High
• This mount will typically fit all scopes with tubes and objective lens up to 58mm, with options to fit even larger scopes.
• Be sure to check that your scope will fit between the rings and that the scope bridge will clear the top of the saddle mount base. Table of dimensions are provided on the product picture.
• Every Blaser scope mount has 12moa elevation built into the saddle base. This makes them a great choice for pairing with scopes with dial up turrets for medium and long range shooting.
• This mount is the new style scope mount and does not accept old style mount rings - see info below to identify if any existing rings you may have will fit this scope mount base.

 

New style mount and rings

The scope mount has recessed slots in the base to accept the new style rings.
The new style rings halves screws are located at the bottom of the ring and screw in at an angle. These rings have a flat bottom to fit into the recessed slot in the new style base.

Old style mount and rings

The old style rings sit proud and on top of mount, not into a recessed in a slot.
The rings halves screws are located halfway up the ring and screw in vertically. This ring has a proud tail to screw into the old style base.

• Old and new rings are not interchangeable between the two style mounts bases. 
• The old style rings do not fit in the new style scope mount base above.
• The new style rings above do not fit into the old style scope mount base below.
• The old style scope mount bases are discontinued.