TRIEBEL BLASER MAGNUM RELOADING DIES 1 1/4″
Triebel Guntools - Quality made in Germany - Since 1948
Triebel Blaser Magnum dies use the wide body 1 1/4 inch thread. This provides superior stiffness and straightness. This is larger than most American standard dies (1 1/4" is the thread normally used on 50cal dies). Alot of presses can accept these, sometimes by removing a bushing on the die holder of the press. Please check yours.
Full length dies
Full length dies are used to size the cartridge case on full length.
In addition to a removable expander our FL dies have an integrated primer ejector pin. All used spindles, the expander and ejector pin can be replaced easily if necessary, with just little effort. Calibration takes place when the cartridge case is pushed into the die. The neck of the case is calibrated from the inside when it is moved out of the die. This will form the cartridge case and achieves a correct neck tension. The correct position of the die in the press is set with the lock nut.
Bullet Seater
Our standard bullet seaters guide the bullet in a separate guide bushing. This ensures good accuracy.
The Bullet Seater is the solid choice for quickly seating the bullet.
Triebel Reloading Dies design:
-
Die body grooves
The grooves on the die body make it easier to install the die in the press. -
High quality optical finish
Due to ground surface and burnished components. -
Die engraving
The Triebel dies are laser marked. -
Fixed lock ring
The nut to secure the die is tightened with an Allen screw that does not press on the die thread. -
Adjusting screw
The screw for easy adjustment of the settling die has a metric thread. -
Securing the adjusting screw
The adjusting screw is secured with a sturdy nut. -
Matched to bullet shape
Interchangeable bullet setting steam for many bullet types available as accessories.
Some dies have small blemishes on the body or on packaging from sitting in storage.
More information visit their website https://www.triebel-guntools.de/en/
